Pennsylvania Code & Bulletin
COMMONWEALTH OF PENNSYLVANIA

• No statutes or acts will be found at this website.

The Pennsylvania Bulletin website includes the following: Rulemakings by State agencies; Proposed Rulemakings by State agencies; State agency notices; the Governor’s Proclamations and Executive Orders; Actions by the General Assembly; and Statewide and local court rules.

PA Bulletin, Doc. No. 20-1140

PROPOSED RULEMAKING

STATE ARCHITECTS
LICENSURE BOARD

[ 49 PA. CODE CH. 9 ]

Digital Signature and Seal

[50 Pa.B. 4241]
[Saturday, August 22, 2020]

 The State Architects Licensure Board (Board) proposes to add §§ 9.140 and 9.141a (relating to definitions; and digital signature) and amend § 9.141 (relating to requirement) to read as set forth in Annex A.

Effective Date

 This proposed rulemaking would become effective upon publication of the final-form rulemaking in the Pennsylvania Bulletin.

Statutory Authority

 Subsection 6(a) of the Architects Licensure Law (act) (63 P.S. § 34.6(a)) authorizes the Board to establish reasonable rules and regulations to carry out the provisions of the act. Further, section 12 of the act (63 P.S. § 34.12) provides the requirement that every architect utilize a seal approved by rules and regulations promulgated by the Board.

Background and Need for this Proposed Rulemaking

 Subsection 12(a) of the act requires each licensee to obtain a seal of a design authorized by the Board and to stamp all work product issued by the licensee with that seal. The Board has promulgated § 9.141 to set standards for licensee use of the seal, including the requirement in § 9.141(b)(2) that the licensee also sign the document. However, these regulations were developed when the seal was applied by means of a metal embosser or a rubber stamp; they did not contemplate that a seal or signature could be placed electronically through the personal use of computer technology by placing an image of the seal or signature on a document and did not contemplate that a document could be signed digitally other than by placing an image of the signature on the document. With such technology now available, the National Council of Examiners in Engineering and Surveying (NCEES), the National organization of engineering and land surveying licensing boards, has addressed its use in paragraph H of section 240.20 (relating to seals) of its Model Rules (https://ncees.org/wp-content/uploads/Model_Rules_2019_web.pdf). Additionally, the Uniform Electronic Transactions Act (UETA) has been adopted by many states, including the Commonwealth. In the Commonwealth, UETA was enacted as the Electronic Transactions Act (73 P.S. §§ 2260.101—2260.5101). The Board has adopted definitions and provisions consistent with the Electronic Transactions Act for these regulations. Other state agencies must comply with the Electronic Transactions Act under section 303(a) (73 P.S. § 2260.303(a)) in that they may not deny the legal effect or enforceability of a seal solely because it is in electronic form.

 This proposed rulemaking will allow licensees to use digital signatures and seals to increase electronic commerce and electronic communications, increase electronic filing of documents, help establish uniformity of rules and standards regarding the authentication and integrity of electronic records and promote public confidence in the integrity and reliability of electronic records. The Board believes that it is appropriate to amend its regulations to make it clear that licensees are permitted to take advantage of this technology and to set standards for its use.

Description of Proposed Amendments

 This proposed rulemaking adds § 9.140 to provide definitions for the newly-used terms ''digital seal,'' ''digital signature,'' ''electronic,'' ''handwritten signature,'' ''sole control'' and ''verification.'' The definitions of these terms are consistent with the same terms as defined by other northeastern states' professional licensure regulatory bodies, the Uniform Electronic Transactions Act, the Electronic Transactions Act, the Digital Signature and Electronic Authentication Law and the Electronic Signatures in Global and National Commerce Act. The profession makes a distinction between electronic versus digital signatures. An electronic signature may include scanned images of handwritten signatures or typed notations such as ''/s/ Jane Doe'' without any authentication or encryption system included. Consistent with NCEES Model Rules, the Board proposes digital signatures and seals because the digital approach more properly describes a system applied to an electronic document that uses specific technical processes to provide significant added signer authentication, document authentication, document encryption (if necessary) and efficiency.

 Additionally, the Board proposes to amend § 9.141(a) to require a licensee to include on the licensee's seal the legend ''registered architect'' together with a reference to the Commonwealth, which is already noted on the Board's web site in reference to required seal design. This proposed rulemaking also amends existing § 9.141(a) to remove the word ''metal'' regarding the type of seal each licensee is required to obtain. Removing this term aligns this section with the other design Board requirements for a seal.

 Next, this proposed rulemaking amends § 9.141(b)(2) by adding ''or digital'' to clarify that architects are permitted to use either a facsimile or digital seal on all subsequent pages of final or complete documents.

 Also, this proposed rulemaking adds § 9.141(b)(5) to require, as does the Model Rule, that a licensee must (i) physically place the seal and handwritten signature in ink, (ii) digitally place the seal and handwrite the signature in ink, or (iii) digitally place the seal and a digital signature.

 Finally, this proposed rulemaking adds § 9.141a, which provides the heart of the regulation by requiring, as does the Model Rule, that documents signed using a digital signature and seal must have an electronic authentication process attached to or logically associated with the document and that this signature and seal must be unique to the licensee, capable of verification, under the sole control of the licensee, and linked to the document in such a manner that the digital signature and seal are invalidated if any data in the document is changed. Subsection (c) adopts language from the Model Rule 240.20 by requiring that any hard copy printed from the transmitted document file must bear the digital facsimile of the signature and seal and be a confirmation that the electronic file was not altered after the initial signing of the file and that any alterations will cause the signature to be voided.

Fiscal Impact and Paperwork Requirements

 Because the use of digital signatures and seals are voluntary rather than mandatory, this proposed rulemaking would not have a fiscal impact on, or create additional paperwork for, the regulated community, the general public, or the Commonwealth and its political subdivisions.

Sunset Date

 The Board continuously monitors the effectiveness of its regulations. Therefore, no sunset date has been assigned.

Regulatory Review

 Under section 5(a) of the Regulatory Review Act (71 P.S. § 745.5(a)), on August 11, 2020, the Board submitted a copy of this proposed rulemaking and a copy of a Regulatory Analysis Form to the Independent Regulatory Review Commission (IRRC) and to the Chairpersons of the Senate Consumer Protection and Professional Licensure Committee and the House Professional Licensure Committee. A copy of this material is available to the public upon request.

 Under section 5(g) of the Regulatory Review Act, IRRC may convey comments, recommendations or objections to the proposed rulemaking within 30 days of the close of the public comment period. The comments, recommendations or objections shall specify the regulatory review criteria which have not been met. The Regulatory Review Act specifies detailed procedures for review, prior to final publication of the rulemaking, by the Board, the General Assembly and the Governor of comments, recommendations or objections raised.

Public Comment

 Interested persons are invited to submit written comments, suggestions or objections regarding this proposed rulemaking to the Regulatory Counsel, Department of State, by mail at P.O. Box 69523, Harrisburg, PA 17106-5923 or by e-mail at RA-STRegulatoryCounsel@pa.gov within 30 days following publication of this proposed rulemaking in the Pennsylvania Bulletin. Reference No. 16A-4111 (Digital Signature and Seal) when submitting comments.

PHILIP M. LEINBACH, RA, 
President

Fiscal Note: 16A-4111. No fiscal impact; (8) recommends adoption.

Annex A

TITLE 49. PROFESSIONAL AND VOCATIONAL STANDARDS

PART I. DEPARTMENT OF STATE

Subpart A. PROFESSIONAL AND OCCUPATIONAL AFFAIRS

CHAPTER 9. STATE ARCHITECTS LICENSURE BOARD

ARCHITECT'S SEAL OF LICENSURE

 (Editor's Note: The following section is proposed to be added and printed in regular type to enhance readability.)

§ 9.140. Definitions.

 The following words and terms, when used in this section and §§ 9.141 and 9.141a, have the following meanings, unless the context clearly indicates otherwise:

Digital seal—An electronic sound, symbol or process attached to or logically associated with a document and executed or adopted by a person with the intent to seal the document.

Digital signature—An electronic sound, symbol or process attached to or logically associated with a document and executed or adopted by a person with the intent to sign the document.

Electronic—Relating to technology having electrical, digital, magnetic, wireless, optical, electromagnetic or similar capabilities.

Handwritten signature—The scripted name or legal mark of an individual, written by that individual and executed or adopted with the present intention to authenticate a writing in a permanent form.

Sole control—A situation in which only the licensee decides when and where the seal is applied.

Verification—Confirmation that a signature is actually from the licensee whose name and license number appears on the document.

§ 9.141. Requirement.

 (a) A licensee shall, upon licensure, obtain a [metal] seal, of the design authorized by the Board, bearing the licensee's name and license number and the legend, [''Architect.''] ''Registered Architect'' together with a reference to the Commonwealth of Pennsylvania. A stamp design identical to the prescribed seal may be obtained and used in lieu of, or in conjunction with, a seal.

 (b) The following rules govern the use of an architect's seal:

 (1) An architect may use [his] the architect's seal and signature only when the work being sealed and signed was prepared by the architect or under the architect's personal supervision, direction and control.

 (2) When an architect issues final or complete documents to a client for the client's records, or when an architect submits final or complete documents to public or governmental agencies for final review, the seal and signature of the architect who prepared or who personally supervised the preparation of the documents, along with the date of issuance, shall be prominently displayed on the first page of all documents. Facsimile or digital seals shall appear on all subsequent pages of plans.

 (3) When an architect's signature is applied, it shall be applied near or across the seal, but not in a location that obliterates the license number.

 (4) An architect may not affix or permit a seal and signature to be affixed to a document if the architect's license has lapsed, or for the purpose of aiding or abetting another person to evade or attempt to evade a provision of the act or this chapter.

(5) When a licensee seals and signs architectural documents, one of the following methods must be used:

(i) Physical placement of a seal and a handwritten signature in permanent ink containing the name of the licensee.

(ii) Digital placement of a seal and a handwritten signature in permanent ink containing the name of the licensee.

(iii) Digital placement of a seal and a digital signature containing the name of the licensee.

 (Editor's Note: The following section is proposed to be added and printed in regular type to enhance readability.)

§ 9.141a. Digital signature and seal.

 (a) Drawings, reports, and documents that are signed using a digital signature must have an electronic authentication process attached to or logically associated with the electronic document. The digital signature must be:

 (1) Unique to the licensee.

 (2) Capable of verification.

 (3) Under the sole control of the licensee.

 (4) Linked to a document in such a manner that the digital signature is invalidated if any data in the document is changed.

 (b) Drawings, reports, and documents that are sealed with a digital seal must have an electronic authentication process attached to or logically associated with the electronic document. The digital seal must be:

 (1) Unique to the licensee.

 (2) Capable of verification.

 (3) Under the sole control of the licensee.

 (4) Linked to a document in such a manner that the digital seal is invalidated if any data in the document is changed.

 (c) Any hard copy printed from the transmitted electronic file shall bear the facsimile of the signature and seal and be a confirmation that the electronic file was not altered after the initial digital signing of the file. Any alterations to the file shall cause the signature to be voided.

[Pa.B. Doc. No. 20-1140. Filed for public inspection August 21, 2020, 9:00 a.m.]



No part of the information on this site may be reproduced for profit or sold for profit.

This material has been drawn directly from the official Pennsylvania Bulletin full text database. Due to the limitations of HTML or differences in display capabilities of different browsers, this version may differ slightly from the official printed version.