Pennsylvania Code & Bulletin
COMMONWEALTH OF PENNSYLVANIA

• No statutes or acts will be found at this website.

The Pennsylvania Bulletin website includes the following: Rulemakings by State agencies; Proposed Rulemakings by State agencies; State agency notices; the Governor’s Proclamations and Executive Orders; Actions by the General Assembly; and Statewide and local court rules.

PA Bulletin, Doc. No. 96-1396

NOTICES

Bureau of Driver Licensing; Implementation of Commercial Driver Licensing Test Procedures

[26 Pa.B. 4142]

   Under Act 115-96, passed into law on July 11, 1996, the Department of Transportation is publishing the test procedures as required by 75 Pa.C.S. § 1607A (relating to commercial driver's license qualification standards):

   (Editor's Note:  Pursuant to section 27 of Act 96, 67 Pa. Code §§ 75.25--75.28 (Pa. Code serial pages (198279) to (198286) are deleted upon publication of the following testing procedures.)

Commercial Driver Licensing Testing Procedures

Overview:

   Driving examination for commercial driver's license.

   (a)  General. In addition to the knowledge examination an applicant for a commercial driver's license shall submit to a driving examination. The driving examination for a commercial driver's license shall be conducted in a test vehicle of the type or class the applicant desires to be licensed to operate. The applicant shall pass the following three parts of the examination:

   (1)  A vehicle safety inspection.

   (2)  A basic control skills test.

   (3)  An on-road driving test.

   (b)  Content of driving examination. The driving examination is composed of methods and procedures that enable the examiner to determine the ability of the applicant to drive the type or class of vehicle for which the applicant desires to be licensed.

Section 1.  Administration of vehicle safety inspection.

   (a)  General. The vehicle safety inspection requires that an applicant complete a safety examination of the test vehicle.

   (b)  Conduct of the inspection.

   (1)  The applicant and examiner will perform a walk around safety examination of the test vehicle. The vehicle safety inspection shall consist of checking:

   (i)  All exterior lighting and reflectors.

   (ii)  The tires to ensure that they are in safe operating condition.

   (iii)  The exterior mirrors.

   (iv)  For major leaks (e.g. air brakes, fluid, coolant, fuel tank, etc.)

   (2)  The examiner will instruct the examinee to enter the vehicle and direct the examinee to operate the following controls:

   (i)  Headlights (high/low beam) and marker lights

   (ii)  Wipers/washers

   (iii)  Turn signals

   (iv)  Hazard warning lights (four ways)

   (v)  Taillights

   (vi)  Brakelights

   (vii)  Horn/horns

   (viii)  Emergency safety equipment

   (3)  The applicant will be required to complete an air brake check of the test vehicle, if the vehicle is so equipped. The applicant shall:

   (i)  Locate and verbally identify air brake operating controls and monitoring devices.

   (ii)  Determine the motor vehicles brake system condition for proper adjustments and that air system connections between motor vehicles have been properly made and secured.

   (iii)  Inspect the low pressure warning device(s) to insure that they will activate in emergency situations.

   (iv)  Ascertain, with the engine running, that the system maintains an adequate supply of compressed air.

   (v)  Determine that required minimum air pressure build up time is within acceptable limits and that required alarms and emergency devices automatically deactivate at the proper pressure level.

   (vi)  Operationally check the brake system for proper performance.

   (4)  In addition to the items in paragraphs (1), (2), and (3), the general condition of the following items shall be inspected and described by applicants who desire to be licensed to operate school buses only:

   (i)  Passenger entry.

   (ii)  Emergency exits.

   (iii)  Seating.

   (iv)  Eight-way light system, activation and explanation.

   (5)  In addition to the items in paragraphs (1), (2), and (3), the general condition of the following items shall be inspected and described by applicants who desire to be licensed to operate coaches and transit buses:

   (i)  Passenger entry.

   (ii)  Emergency exits.

   (iii)  Seating.

   (c)  Scoring/Failure criteria. The applicant will be given one point for each item that is correctly inspected and described. The following values apply to passing or failing the vehicle safety inspection.

   (1)  Automatic failures:

   (i)  Failure to attempt the air brake test, if the vehicle is so equipped.

   (ii)  Failure to correctly perform the eight-way light inspection on a school bus.

   Scoring the Vehicle Safety Inspection test:

   One (1) point will be scored for the following if done correctly:

   (a)  Headlights (high/low beam)

   (b)  Wipers/washers

   (c)  Turn signals

   (d)  Hazard warning lights (four ways)

   (e)  Taillights

   (f)  Brakelights

   (g)  Horn/Horns

   (h)  Emergency safety equipment

   School Bus only:

   (i)  Axe/Pry bar

   (j)  First aid kit

   Air Brake only:

   (k)  Leak test

   (l)  Low air warning devices

   (m)  Emergency brake activation

   (n)  Air pressure build up

   Total Points:  Class A, B, C, CDL, 8 (12 with air brakes) School Bus 10 Passing Score:  6 (with air brakes 10) School Bus 8

Section 2.  Administration of basic control skill test.

   (a)  General. In addition to the vehicle safety inspection, the basic control skills test will be administered to an applicant for a commercial driver's license. This test evaluates the applicant's ability and judgment to safely operate a commercial motor vehicle.

   (b)  Content of test. The basic control skills test is composed of methods and procedures which enable the examiner to determine the applicant's ability to control the vehicle and judge the position of the vehicle in relationship to other objects. The test will be administered in one of the forms described in paragraphs (1)--(4). The test will be conducted on an on-road or off-road test site. The examiner will select which form to use based on the layout of the test site.

   (1)  Form 1. Straight line backing, alley docking, sight-side parallel parking and conventional parallel park.

   (2)  Form 2. Right turn, alley docking, conventional parallel parking and backward serpentine.

   (3)  Form 3. Straight line backing, alley docking, conventional parallel parking and backward serpentine.

   (4)  Form 4. Straight line backing and one of the following:  alley docking, backward serpentine, conventional parallel parking or sight-side parallel parking.

   (c)  Scoring/failure criteria. Scoring in the basic control skills test will be based on pullups, encroachments and final vehicle positioning. Each time an applicant stops and reverses direction to get a better position, it is scored as a pullup. If an applicant touches or crosses over an exercise boundary standard with any part of the vehicle, it is scored as an encroachment. The following values apply to passing or failure of the basic control skills test:

   (1)  Automatic failures.

   (i)  Refusal to obey instruction of the examiner.

   (ii)  Refusal to attempt a maneuver when instructed to by the examiner.

   (iii)  Offering bribe or gratuity to the examiner.

   (iv)  Cheating, fraud, or misrepresentation.

   (v)  Permit violation.

   (vi)  Commercial endorsement violation.

   (vii)  Commercial restriction violation.

   (viii)  Medical restriction violation.

   (2)  Minimum passing scores for Forms 1 through 4:

   (i)  Form 1-16 errors or less.

   (ii)  Form 2-14 errors or less.

   (iii)  Form 3-12 errors or less.

   (iv)  Form 4-4 errors or less.

Section 3.  Administration of on-road-driving test.

   (a)  General. In addition to the vehicle safety inspection and the basic control skills test, an applicant for a commercial driver's license shall submit to an on-road driving test.

   (b)  Contents of test. The on-road driving test is to evaluate the applicant's ability to operate a commercial motor vehicle safely in most on-road conditions, and is administered behind the wheel over a predetermined route on which the applicant shall perform one or more of the following maneuvers:

   (1)  Driving and demonstrating lane changes in traffic.

   (2)  Driving and executing left and right turns.

   (3)  Driving on curves and demonstrating turning.

   (4)  Driving and demonstrating expressway merging, lane changes and exit.

   (5)  Demonstrating driving ability at intersection or railroad crossing, or both.

   (6)  Demonstrating ability to start and stop on grade.

   (7)  Driving on an up grade and down grade.

   (8)  Driving on a bridge or through an underpass, or both.

   (9)  Demonstrating general driving behavior.

   (c)  Scoring/failure criteria. The applicant's score on the on-road test will be based on the number of errors committed during the test. An accumulation of 26 or more errors constitutes a failed test. In addition, the following faults constitute automatic failure of the on-road driving test:

   (1)  Failure to obey traffic laws.

   (2)  Culpability for an accident during the test.

   (3)  Failure to perform the simulated steep down-grade maneuver at the basic control skills test site properly.

   (4)  Refusal to obey instructions of the examiner.

   (5)  Refusal to attempt a maneuver when instructed to by the examiner.

   (6)  Offering bribe or gratuity to the examiner.

   (7)  Cheating, fraud or misrepresentation.

   (8)  Permit violation.

   (9)  Commercial endorsement violation.

   (10)  Commercial restriction violation.

   (11)  Medical restriction violation.

BRADLEY L. MALLORY,   
Secretary

[Pa.B. Doc. No. 96-1396. Filed for public inspection August 23, 1996, 9:00 a.m.]



No part of the information on this site may be reproduced for profit or sold for profit.

This material has been drawn directly from the official Pennsylvania Bulletin full text database. Due to the limitations of HTML or differences in display capabilities of different browsers, this version may differ slightly from the official printed version.