Pennsylvania Code & Bulletin
COMMONWEALTH OF PENNSYLVANIA

• No statutes or acts will be found at this website.

The Pennsylvania Bulletin website includes the following: Rulemakings by State agencies; Proposed Rulemakings by State agencies; State agency notices; the Governor’s Proclamations and Executive Orders; Actions by the General Assembly; and Statewide and local court rules.

PA Bulletin, Doc. No. 03-2067

RULES AND REGULATIONS

Title 25--ENVIRONMENTAL PROTECTION

ENVIRONMENTAL QUALITY BOARD

[25 PA. CODE CH. 130]

[33 Pa.B. 5618]

[Correction]

Architectural and Industrial Maintenance Coatings

   A numbering error appeared at 33 Pa.B. 5297 (October 25, 2003) in the adoption of Chapter 130, Subchapter C (relating to architectural and industrial maintenance coatings). The sections in Subchapter C should be numbered §§ 130.601--130.611.

   Two additional errors appeared in § 130.303, Table 1 (renumbered § 130.603) and § 130.311(a)(1) (renumbered § 130.611). The corrected version appears in Annex A.

Annex A

TITLE 25.  ENVIRONMENTAL PROTECTION

PART I.  DEPARTMENT OF
ENVIRONMENTAL PROTECTION

Subpart C.  PROTECTION OF
NATURAL RESOURCES

ARTICLE III.  AIR RESOURCES

CHAPTER 130.  STANDARDS FOR PRODUCTS

Subchapter C.  ARCHITECTURAL AND INDUSTRIAL MAINTENANCE COATINGS

§ 130.603.  Standards.

*      *      *      *      *

Table 1

*      *      *      *      *

VOC Content
Coating Category Limit
*      *      *      *      *
--Varnishes 350

*      *      *      *      *

§ 130.611.  Compliance provisions and test methods.

   (a)  Calculation of VOC content. For the purpose of determining compliance with the VOC content limits in § 130.303 Table 1 (relating to VOC content limits for architectural and industrial maintenance coatings), the VOC content of a coating shall be determined by using the procedures described in this subsection or subsection (b), as appropriate. The VOC content of a tint base shall be determined without colorant that is added after the tint base is manufactured.

*      *      *      *      *

   (2)  For low solids coatings, determine the VOC content in units of grams of VOC per liter of coating thinned to the manufacturer's maximum recommendation, including the volume of any water and exempt compounds. Determine the VOC content using Equation 2 as follows:

Equation 2:  VOC Content (ls) =
(Ws - Ww - Wec)
________________
         (Vm)

Where:

VOC Content (ls) = the VOC content of a low solids coating in grams of VOC per liter of coating

Ws = weight of volatiles, in grams

*      *      *      *      *

[Pa.B. Doc. No. 03-2067. Filed for public inspection October 24, 2003, 9:00 a.m.]



No part of the information on this site may be reproduced for profit or sold for profit.

This material has been drawn directly from the official Pennsylvania Bulletin full text database. Due to the limitations of HTML or differences in display capabilities of different browsers, this version may differ slightly from the official printed version.