Pennsylvania Code & Bulletin
COMMONWEALTH OF PENNSYLVANIA

• No statutes or acts will be found at this website.

The Pennsylvania Code website reflects the Pennsylvania Code changes effective through 54 Pa.B. 5070 (August 3, 2024).

25 Pa. Code § 78.96. Marking the location of a plugged well.

§ 78.96. Marking the location of a plugged well.

 Upon the completion of plugging or replugging a well, the operator shall erect over the plugged well a permanent marker of concrete, metal, plastic or equally durable material. The marker must extend at least 4 feet above the ground surface and enough below the surface to make the marker permanent. Cement may be used to hold the marker in place provided the cement does not prevent inspection of the adequacy of the well plugging. The permit or registration number shall be stamped or cast or otherwise permanently affixed to the marker. In lieu of placing the marker above the ground surface, the marker may be buried below plow depth and shall contain enough metal to be detected at the surface by conventional metal detectors.

Source

   The provisions of this §  78.96 adopted July 28, 1989, effective July 29, 1989, 19 Pa.B. 3229; amended February 4, 2011, effective February 5, 2011, 41 Pa.B. 805. Immediately preceding text appears at serial page (241932).

Cross References

   This section cited in 25 Pa. Code §  78.86 (relating to defective casing or cementing); 25 Pa. Code §  78.91 (relating to general provisions); and 25 Pa. Code §  78.407 (relating to plugging gas storage wells).



No part of the information on this site may be reproduced for profit or sold for profit.


This material has been drawn directly from the official Pennsylvania Code full text database. Due to the limitations of HTML or differences in display capabilities of different browsers, this version may differ slightly from the official printed version.